12
2020/05
The shaftless screw conveyor has an appropriate rotational speed.
The screw blades of the shaftless screw conveyor are cast from stainless steel using specialized molds, ensuring sufficient strength and rigidity. The blade surfaces are smooth and free of burrs, and the rotational speed is appropriately optimized to effectively prevent fouling and blockage during the conveyance of screen screenings. Moreover, even under high-capacity operation, the screw blades remain deformation-free.
The screw blades of the shaftless screw conveyor are cast from stainless steel using specialized molds, ensuring adequate strength and rigidity. The blade surfaces are smooth and free of burrs, and the rotational speed is appropriately optimized to effectively prevent fouling and blockage during the conveyance of screen screenings. Moreover, even under high-capacity conveying conditions, the screw blades remain deformation-free.
The shaftless screw conveyor consists of a shaftless screw, a U-shaped screw trough, cover plates, lining plates, inlet and outlet openings, a discharge port, and a drive unit. Material is fed in through the inlet, conveyed by the shaftless screw, and discharged through the outlet. The drive unit is mounted at one end of the conveyor and features a direct connection between the motor–reducer assembly and the screw drive shaft, eliminating the need for a coupling. This design facilitates easy disassembly and maintenance, while the drive shaft is capable of withstanding combined bending moments and axial thrust loads. The drive motor is rated for 380 V, three-phase, 50 Hz operation, with an IP55 protection rating (for outdoor use) and an F-class insulation class. The wear-resistant lining inside the U-shaped screw trough is shaped as a semicircle, with its arc precisely matching the radius of the shaftless screw to minimize excessive clearance and enhance conveying efficiency. Made from high-wear-resistance nylon, the lining is easy to install and replace, ensuring a long service life. The U-shaped screw trough is fabricated by rolling stainless-steel plate; except for the open inlet, all other sections are sealed with flat covers along the length of the trough, ensuring that the entire conveying process takes place within a sealed enclosure, thereby reducing noise and minimizing odor emissions. A discharge port is provided at the bottom of the U-shaped trough, equipped with a drain ball valve.
The shaftless screw conveyor features no high-speed rotating parts, resulting in minimal wear on the conveying screw, lower energy consumption, and reduced noise levels. Installation is straightforward: simply secure the structural steel supports to the concrete foundation using expansion bolts. The equipment can operate either intermittently or continuously for 24 hours a day. The electrical design incorporates overload protection, ensuring safe and efficient round-the-clock operation. The electrical control components for the shaftless screw conveyor are housed in the on-site electrical control cabinet for the screen, with detailed control requirements specified in the screen’s electrical control section.