Hi

Contact us for more special prices!

Get a free product quote

Please provide your phone number and email address, and we will contact you promptly within one business day to resolve your issue as soon as possible.


10

2020/09

Working Principle of the Z-Type Bucket Elevator


Working principle of the Z-type bucket elevator: The buckets scoop up the material from the lower storage bin, lift it to the top along the conveyor belt or chain, pass over the head pulley and then invert as they descend. The bucket elevator then discharges the material into the receiving hopper. In belt-driven bucket elevators, the drive belt is typically made of rubber and is mounted on the drive drums at the bottom and top as well as on the idler drums at the top and bottom. Chain-driven bucket elevators generally have two parallel drive chains, with a pair of drive sprockets at the top or bottom and a pair of idler sprockets at the bottom or top. Bucket elevators are usually equipped with a casing to prevent dust from escaping during operation.

    Z-type bucket elevator Working Principle

The buckets scoop material from the storage bin below, convey it upward on a belt or chain, pass over the head pulley, and then invert as they descend. The bucket elevator then discharges the material into the receiving hopper. In belt-driven bucket elevators, the drive belt is typically made of rubber and is mounted on the lower or upper drive drum as well as the upper and lower idler drums. Chain-driven bucket elevators generally employ two parallel drive chains, with a pair of drive sprockets at the top or bottom and a pair of idler sprockets at the bottom or top. Bucket elevators are usually equipped with a casing to prevent dust from escaping during operation.

Suitable for lifting materials from a lower to a higher position: after the materials are fed into the hopper via a vibrating feeder, the machine automatically operates continuously to convey them upward.

    Z-type bucket elevator Main Components

A bucket elevator consists of a casing, traction elements, buckets, a drive sprocket, a return sprocket, a tensioning device, a guiding device, a feed inlet, and a discharge outlet.

    Z-type bucket elevator Operation and Maintenance Procedures

1. During operation, the bearing at the bottom of the head pulley and the temperature rise of the reducer shall be inspected once per shift. If the surface feels scalding to the touch after about 10 seconds, this indicates excessive temperature rise, and the root cause must be identified. Corresponding measures, such as adding lubricant or cleaning the bearings and reducer, shall then be implemented.

2. Grease the bottom bearing of the head wheel once a month.

3. During operation, carefully monitor for any abnormal noises, slippage of the bucket belt, and overheating of the bearings and reducer.

4. For newly installed bucket belts, adjust the adjusting screw on the base to tension the belt every two shifts of operation (when the elevator is running under load for more than 10 hours). Once the adjusting screw has been turned to its lowest position, the bucket belt must be cut and shortened to restore proper tension.

5. Clean the accumulated material in the hoist base once a week.

6. Each time the head cover is opened, any material adhering to the cover must be thoroughly cleaned off. The head cover should be cleaned at least once a month.

7. Before shutting down, stop feeding and run the machine empty for 3–4 minutes to ensure all material is discharged.